![]() ![]() ![]() The instructions in this chapter tell you what to do to get to a point where you can inititiate an interactive Solaris installation or a Jumpstart installation on the blade. Also, the Network Install Server and the DHCP server need to be configured for each individual blade, otherwise the network installation will not work. PXE booting is supported by DHCP services, and this means that there are a number of setup steps you need to perform involving the DHCP server. ![]() The B100x and B200x blades use a PXE-based network installation method to receive the Solaris x86 operating system. Section 10.13, The New add_install_client -b Optionġ0.1 Overview of the Solaris x86 Installation Procedures.Section 10.12, Installing Solaris x86 Onto a Blade by Using the Second, Third, or Fourth Network Interface.Section 10.11, Useful Tips for Installing Solaris x86 onto Multiple Blades.Section 10.10, Configuring a Jumpstart Installation.Section 10.9, Preparatory Steps for Setting up a Jumpstart Installation for a Blade.Section 10.8, Specifying Disk Partitioning During an Interactive Installation.Section 10.7, Monitoring the Network Booting Process and Starting the Solaris Installation.Section 10.6, Configuring a Blade to Boot Temporarily From the Network.Section 10.5, Re-initializing the Hard Disk On a Blade That Previously Ran Linux.Section 10.4, Configuring the Install Server and the DHCP Server to Install Solaris x86 Onto Each Blade.Section 10.3, Configuring Global Settings for Solaris x86 Blades on the DHCP Server. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |